SZM 3 inch cold air intake kit for Nissan GT-R R35 - mandrel-bent aluminium intake pipes with dual-cone filters
SZM 3 inch cold air intake pipes for Nissan GT-R R35 VR38DETT
SZM 3 inch dual cone high-flow air filter for Nissan GT-R R35
SZM 3 inch cold air intake kit for Nissan GT-R R35 - mandrel-bent aluminium intake pipes with dual-cone filters
SZM 3 inch cold air intake pipes for Nissan GT-R R35 VR38DETT
SZM 3 inch dual cone high-flow air filter for Nissan GT-R R35

SZM 3 INCH COLD AIR INTAKE

Price
Regular price
Dhs. 2,700.00 AED
Sale price
Dhs. 2,700.00 AED
Regular price
Shipping calculated at checkout.
Available 10 Items in Stock

The SZM 3-Inch Cold Air Intake is a complete bolt-on induction kit for the Nissan GT-R R35 (2009 onwards), combining SZM's 76mm mandrel-bent aluminium intake pipes with a matched pair of SZM 3" dual-cone high-flow air filters. It replaces the restrictive factory airboxes and gives the MAF sensors the headroom needed for builds pushing beyond 650-700 WHP.

What's in the kit

  • 1 × SZM 3" Cold Air Intake Pipes: mandrel-bent aluminium, one per bank, with stainless steel T-bolt clamps and mounting brackets
  • 2 × SZM 3" Dual-Cone High-Flow Air Filters: 76mm neck, 114mm width, 170mm height, washable and reusable

Why upgrade to a 3-inch intake?

  • Removes the factory flow bottleneck. The OEM airboxes choke top-end airflow; the 76mm mandrel-bent pipes hold a constant cross-section from filter to turbo inlet.
  • Keeps MAF readings honest past 650 WHP. Larger tubing gives the tuner usable Mass Air Flow range instead of a pegged sensor.
  • Doubles the filtration surface. The dual-cone element flows more air at the same restriction as a single cone, and is washable rather than disposable.
  • Audible spool. Removing the airboxes uncovers the VR38DETT turbo and blow-off noise.

Does it fit my GT-R?

Yes. All Nissan GT-R R35 model years, 2009 to current, are covered. No cutting or permanent modification is required; the kit clamps to the factory turbo inlets.

What power level is this intake good for?

The 3" size suits Stage 1 through Stage 3 builds and supports roughly 650-700 WHP. Builds above that should step up to the 3.5" or 4" induction sizes.

Do I need a retune after fitting it?

A retune is strongly recommended. The intake changes measured airflow, so the ECU should be recalibrated to take advantage of it safely.

How long does installation take?

Roughly 1 to 2 hours with basic hand tools. The filters clamp on; the pipes bolt to the factory mounting points.

Are the filters serviceable?

Yes. The dual-cone filters are washable and reusable. Clean and re-oil rather than replace, typically every 75,000 km under normal driving.

Where does it ship from?

Subzero Motorsports stocks this kit in Dubai, United Arab Emirates, with worldwide shipping available.

SZM 3 INCH COLD AIR INTAKE

Recommended For You